close
close
close

How to wire a RGB Data Repeater / Amplifier

Posted by Light.co.nz on 19th Feb 2015

One RGB controller can only supply certain amount of power e.g. 120W. What if a longer run of RGB LED strips is required? The answer is RGB Data Repeater / Amplifier. With this device, you can control whatever length of LED strips at once!

Below is a very simple wiring diagram for LT-3060: 3 channel Data Repeater / Amplifier.

Hot tips:

1. Even the power rating of your controller is sufficient, make sure you add a repeater every 10m to avoid voltage drop / brightness drop.

2. Our repeaters work on single colour LED strips as well. Find out how by calling 0800 66 65 64

to top